EzOSD Firmware Releases

v1.14	- New Feature: mWh efficiency calculation, computes plane and motor/battery efficiency - Code optimizations, revised menu structure - Refer to readme1st.txt prior to upgrading!
v1.06	- New Feature: Downlink the battery info (V, A, mAh) for display on the Antenna Tracker, and ImmersionRC Player - New Feature: Add center-screen alarm message, which indicates when any of the alarms fire (ensuring that the pilot notices the alarm) - New Feature: Full support for the EzUHF Receiver, via i2c link - Bug Fix: Increase wait-time before auto-sensing Lipo cell count, to prevent a rare problem where the threshold voltage was incorrectly set.
v1.02	- Support for the new 10Hz GPS module - Summary Screen can now be disabled, at the request of the MikroKopter community (enable/disable on the second menu page)
v1.0	- 900MHz telemetry fix (select 'High' telemetry mode, and use v1.03 antenna tracker firmware) - Show # satellites on the 2nd display line when it drops below a reasonable count - Flight summary suppressed if GPS sat. count drops in flight - RSSI min/max values may be configured in the new menu - Fix for a very rare flash memory corruption problem - Faster startup + improved detection of GPS modules with non-std. baud rates - Slightly shorter GPS time-to-lock (in some cases)

EzOSD Custom/Beta Firmware

None	No beta/custom firmware available at this point

NOTE: Some of the files presented on this page contain un-released software, which have not been thoroughly tested, use at your own risk!

To upgrade firmware in the EzOSD, please use the ImmersionRC tools application.