ImmersionRC Ghost

Made For FPV...

Buy Now

For race, nothing comes close

The fastest commercial control system. 500Hz, with lower average ‘stick to control’ latency than anything else in the business.

Multiple modes, interference-proof LoRa based PureRace, a blistering fast Race250 mode, with full telemetry, and an unmatched Race500.

A new Solid250 mode does the impossible, entire races with no dropped packets, for pro racers this lets them focus on the flying, on the winning, instead of the link. When this happens, our job is done.

Extensively tested, approved, and heavily influenced by the world’s leading Drone Racing Team, XBlades.

One Product, Multiple Personalities

Not only best-in-class on the race circuit, but also one of the longest range commercial 2.4GHz control system.

LoRa modulation mode, with unmatched sensitivity, and typical range of >40km * with a 12dB link margin.

Same transmitter, same receiver, same antennas. Reliable long range control is a menu setting away.

* Independently tested out to 27km with the much lower sensitivity Pure Race mode. 

Smallest Receivers

For the wonderful world of ‘micros’, tiny full featured FPV models which weigh no more than a few grams, the tiny Zepto receiver has no competition.

A paltry 10 x 10mm (3/8 inch x 3/8 inch), and featherweight 0.6g, is about as good as it gets.

These are not crippled ‘reduced range’ receivers; they have the same ridiculous range as the larger Atto receivers.

Dual Independent Receivers

We took the tiny Atto receiver , and without adding a square mm of board space, we added a fully independent second receiver, giving birth to the Atto Duo.

No antenna null dropouts on long range models, no frame-blocking dropouts on race quads.

For the size, this product has no competition, period.

Multiple Standards

Ghost transmitters are available in two standard sizes, compatible with the vast majority of R/C radios used in the FPV world.

The ubiquitous ‘JR’ module, and its little brother, the ‘Lite’ module.

Each sporting an intuitive OLED-based user interface, with joystick control, for simple setup even stand-alone without a ‘smart’ R/C radio.

When installed into an OpenTx based radio, the user interface is mirrored on the radio’s display, using a native (and highly responsive) OpenTx menu.

Also, full integration into FrSky’s new ETHOS™ radios with the Ghost Lite module.

Native GHST protocol support in all popular FPV flight controller firmware platforms.

Fully Integrated Video Transmitter Control

Direct control of a Tramp HV, or Tramp Nano video transmitter without any complex Flight Controller setup.

Automatic power-down on failsafe, or before the R/C link is established.

Trivial installation and configuration using the unique Ghost Hybrid solution.

Combine with the Orqa FPV.Connect, with integrated Ghost, for automatic tracking of goggle channel to video transmitter channel.

Automatic Goggle Channel Control with FPV.Connect

Specifications

Retail Price, Launch Bundle  ($USD): $149.95 USD  (1x JR Module, 3x Átto Rx, 3x uT Antenna)
Launch Date: 6-Aug-2020
Frequency: 2.4GHz License-Free Band
Modulation: Chirp Spread Spectrum + Adaptive FHSS
Binding: Bidirectional, with confirmation and protocol negotiation
RF Profiles: Initially 4, Race, Pure Race, ‘Normal’, and Long Range, more to come

JR Transmitter Module Specifications

Retail Price ($USD): $89.95 USD  (1x JR Module, 2x Tx Antennas)
Uplink RF Power: 16uW – 350mW (+/- 0.5dB)
Frame Rate: 250Hz (purerace), 250Hz (race250), 160Hz (race), 55Hz (normal), 15Hz (long range)
Format: Standard JR Module, tested with FrSky Taranis™, and RadioMaster™ radios
Antennas: Twin antenna, with Tx-side diversity. Antennas are 2.1dBi Dipoles
Compatibility: Any R/C Tx which accepts JR modules (Taranis, etc. )
Serial Formats: SBus, GHST (Auto-Sense)
Firmware: USB Upgradable (with OTA updates for receivers)
Power Supply: 6V-20V, 1.75W @ 400mW, ~250mA at 7.4V

Lite Transmitter Module Specifications

Retail Price ($USD): $69.95 USD  (1x XLite Module, 1x Tx Antennas)
Uplink RF Power: 16uW – 350mW (+/- 0.5dB)
Frame Rate: 250Hz (purerace), 250Hz (race250), 160Hz (race), 55Hz (normal), 15Hz (long range)
Format:Standard ‘Lite’ Module, tested with FrSky X-Lite™, and FrSky X9-Lite™ radios
Antennas: Single antenna, 2.1dBi Dipoles
Compatibility: Any R/C Tx which accepts ‘Lite’ modules (Including the new FrSky ETHOS™ radios)
Serial Formats: SBus, GHST (Auto-Sense)
Firmware: USB Upgradable (with OTA updates for receivers)
Power Supply: 6V-20V, 1.75W @ 400mW, ~250mA at 7.4V

Atto Receiver Specifications

Retail Price ($USD):$29.95 USD  (1x Atto Receiver, 1x qTee Antenna, Silicone Cables, Heat Shrink)
Downlink RF Power: +13dBm
Sensitivity: -117dBm in Long Range mode
Serial Formats: SBus, SBus-Fast (200k) , SRXL-2 (400k), GHST, SBus Inverted
Firmware: Over-the-air (OTA) upgradable
Power Supply: 5V recommended, as low as 3.6V tolerated, no more than 5.5V
vTx Control: Tramp control from ‘T’ pin on Rx, regardless of selected serial format
Antenna Connector: Standard U.FL (vs. Zepto which uses the much smaller MHF4)
Dimensions: 14.8mm x 11.5mm, 0.6g (w/o antenna)
Rx Noise Floor Analysis: Auto on power-up, or on demand from the Tx

Zepto Receiver Specifications

Retail Price ($USD):$29.95 USD  (1x Zepto Receiver, 1x micro qTee Antenna w/50mm cable, Silicone Cables, Heat Shrink)
Downlink RF Power: +13dBm
Sensitivity: -117dBm in Long Range mode
Serial Formats: SBus, SBus-Fast (200k) , SRXL-2 (400k), GHST, SBus Inverted
Firmware: Over-the-air (OTA) upgradable
Power Supply: 5V recommended, as low as 3.6V tolerated, no more than 5.5V
vTx Control: Tramp control from ‘T’ pin on Rx, regardless of selected serial format
Antenna Connector: Standard MHF4 (vs. Atto which uses the larger U.FL)
Dimensions: 10.0mm x 10.0mm, 0.38g (w/o antenna)
Rx Noise Floor Analysis: Auto on power-up, or on demand from the Tx

Hybrid Rx+Tx Specifications

Retail Price ($USD):TBD USD  (1x Ghost Hybrid, 1x qTee Antenna, 1x U.FL to SMA, Wire Harness, 4x Gummies)
Downlink RF Power: +13dBm
Sensitivity: -117dBm in Long Range mode
Serial Formats: GHST, SBus, SBus-Fast (200k) , SRXL-2 (400k), SBus Inverted
Firmware: Over-the-air (OTA) upgradable (Rx and VTx)
Power Supply: 5V, with Over Voltage Protection
vTx Control: Automatic, via Ghost
Antenna Connectors: Standard U.FL with Locking Connectors
Dimensions: 26mm x 126mm, 2.2g (w/o antennas)

Proton Pack Specifications

Retail Price ($USD): 9.95 USD for a Triple Pack (3x Proton Packs, 6x Custom headers, 12x Silicone Gummies)
Compatibility: Tramp Nano with Ghost Atto, Zepto, or Atto Duo

The most common Proton Pack, 20 x 20mm, single sided and very low profile for an incredibly clean, and robust stack.
Silicone gummies for Rx/Tx protection during the occasional hard knock.

25.5 x 25.5 mounting holes, designed for the Five33 Tiny Trainer.
Ghost Atto/Atto Duo/Zepto, plus a Tramp Nano, on a tiny single-sided PCB.

For larger models, with 30 x 30 stacks. Same clean single-sided design, with mounting point for a TNR tag.

Orqa FPV.Connect Integration Specifications

Retail Price ($USD): 29.95 USD for Atto, 69.99 for FPV.Connect
Compatibility: Ghost Atto only, mounted on Orqa FPV.Connect board

A standard Ghost Atto, when mounted on an Orqa FPV.Connect option board, can ‘bind’ to the Ghost Tx and automatically update the Orqa FPV.One video transmitter channel when changed on the Ghost user interface.

The FPV.Connect integrates the 2.4GHz antenna for the Ghost Atto, and is connected via a short u.Fl jumper cable.

Team race, and race quad switching at the press of a button